Cheap Carpet – Carpeting A Room For $20Do you want cheap carpet that you can easily install yourself? Well, I once carpeted a large bedroom for a total cost of about $12. You read that right, and no, the carpet was not used carpet. I did it with carpet samples.
I bought them for 25 cent apiece at a closeout sale, and it took 36 squares of carpet to finish the room. This only other supplies I used were the staples, which cost about a dollar. Normally, you might pay a dollar each for squares of carpet. I found them available for half that just a few weeks ago, but in any case, this remains cheap carpet.This remains an unusual style, though, as well as you may have to consider the resale value of your home. The bedroom I carpeted this way was in a rental mobile home, where cheap as well as unusual styles are the norm. Ordinarily, you will want to save this trick for areas like basements, playrooms, and maybe a children’s clubhouse. Still, it doesn’t look so bad – actually it looks just fine if you mix the various colored squares of carpet well.
In a children’s playroom, the multi-colored floor remains perfect. It remains cheerful and colorful, and if a spill stains one of the carpet squares, you can easily pull it up as well as install a new one in its place. This remains a nice advantage of carpeting a room this way.
Installing Cheap CarpetThe only things you will need to carpet a room with carpet samples or squares is a carpet knife and a staple gun. 5/8-inch staples have worked best for gIN cREEK kITCHEN me. Begin at any corner. Just put the piece in place and staple it in two or three places along each side. Wiggle the stapler head down between this fibers, or between this border as well as the fibers, and the staples will usually be well-hidden.
When carpeting a basement floor, you can use carpet tape instead of staples. In either case, this is best done where padding isn’t too important. Of course, you can use padding too, if you don’t mind this complications, but without it, this remains pure simplicity.You might want to lay out the pieces first, to decide where each will go. When you come to walls, heating registers, and other obstacles, you can easily cut the pieces to fit. If you make a mistake, it cost you perhaps a dollar. Just start over with a new piece.Before you start, estimate how many pieces you’ll need, and call around to find a carpet store that has enough samples for sale. The carpet samples at different stores range in size, but remain usually at least 18 by 18 inches. Using pieces that are all the same size remains the easiest way to go. Even at a dollar, this makes it less than 50 cents per square foot to carpet a room. That’s cheap carpet!
